Land Pride AFM4214 User Manual download pdf (Page 17)

Section 1: Assembly and Set-up

11/14/08

AFM4214 and AFM4216 All-Flex Grooming Mowers 315-587M

Land Pride

Table of Contents

d. Hold locks in this position until all 3 mower decks

have unfolded enough to allow lock lugs to

become fully disengaged.

e. Extend all 3 cylinders to their maximum stroke.

Pull Ropes

Figure 1-5

Gauge Wheel Assembly

Refer to Figure 1-6:

Center deck gauge wheels (#4) are mounted in the

carrier frames spindle support tubes upside down.

1. Remove nuts (#7) and bolts (#6) from the center

deck carrier frames and remove gauge wheels from

the frames.

2. Check spacer location on the other gauge wheels.

Note how many and what sizes are above and below

the gauge wheel spindle support tube and then place

an equal number of spacers (#1, 2 & 3) and sizes

above and below the spindle support tube while

inserting the gauge wheel spindle into the spindle

support tubes.

Center Deck Rear Gauge Wheels

Figure 1-6

13660

Spring Loaded

Transport Locks

IMPORTANT: Do not bend spring steel mounting

bracket supporting the slow moving vehicle sign. This

sign is purposely angled so that when the deck is

folded up for transporting, the sign will face trafﬁc.

26620

Leave Slow Moving Vehicle Sign angled.

This sign should face trafﬁc when deck

is folded up for transporting.

Hydraulic Hook-up

Refer to Figure 1-4:

This mower is equipped and plumbed from the factory

with double acting cylinders, hydraulic hoses and

couplings for folding the wings and center deck.

Hydraulic Hook-up

Figure 1-4

1. Cut plastic ties securing hydraulic hoses (#1) to hose

support loop (#2). Be careful not to cut plastic tie

securing the ten linch pins (#5) to the support loop.

2. Route hoses (#1) through hose support loop (#2)

and connect to tractor remote outlets. Quick

disconnect hydraulic fittings for your tractor are

supplied attached to the hoses.

3. Locate carbon steel wire (#3) attached between wing

cylinders (#4). This wire secures the wing decks in

the folded position during shipment. Remove wire

and dispose of it in a trash container.

Pull Rope Hook-up

Refer to Figure 1-5:

The operator on the tractor seat will need to be able to

access the pull rope from the tractor seat when lowering

the folded decks to ground level.

1. Attach pull rope (#1) to an area within the operator’s

reach. Make sure the pull rope can not become

tangled with the operator and driveline.

2. Unfold mower decks as follows:

AFM4216 Model Only

Refer to Figure 2-3 on page 18:

a. If attached, remove wing deck floating pins and

store in storage tube (#2).

AFM4214 & AFM4216 Models

Refer to Figure 1-5:

b. Retract hydraulic cylinders to remove weight from

transport locks.

c. Pull transport lock rope (#1) toward the tractor to

disengage locks.

26622

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Comments to this Manuals

No comments

Land Pride AFM4214 User Manual Page 17

Comments to this Manuals

Related products and manuals for Garden tools Land Pride AFM4214