Land Pride RCR1872 User Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
9
Section 1: Assembly and Set-Up
12/17/07
RCR1860 and RCR1872 Series Rotary Cutters 312-849M
Land Pride
Table of Contents
Gearbox Vent Plug
Refer to Figure 1-2:
Remove gear box fill plug and replace with combination
vent/level plug shipped separate with Operator’s
Manual.
Figure 1-2
Tractor Hook-Up
Refer to Figure 1-3:
!
DANGER
Tractor hook-up to equipment is dangerous and can result in
serious injury or death. Do not allow anyone to stand between
Rotary Cutter and tractor during hook-up operations. Do not
operate hydraulic 3-point lift controls while someone is
directly behind tractor or near the cutter.
A 3-Point Category I hitch is required. The lower 3-Point
arms of the 3-Point hitch must be stabilized to prevent
side-to-side movement. Most tractors have sway blocks
or adjustable chains for this purpose.
20822
Oil Plug
DO NOT
OVERFILL
Vent Plug
1. Locate cutter on a flat level surface.
2. Slowly back tractor up to the Rotary Cutter while
using the tractor’s 3-point hydraulic control to align
lower 3-point arm holes with clevis lug holes on the
cutter.
3. Engage tractor park brake, shut tractor engine off
and remove key before dismounting from tractor.
4. With tractor’s lower hitch arms aligned and
positioned in the clevises, attach lower arms to the
clevises with hitch pins and secure with linch pins.
5. Connect top center 3-point link to upper pivot hitch
using customer supplied clevis pin and linch pin.
6. Ensure that the lower hitch arms are blocked to
prevent excessive side movement.
7. Return to the tractor and slowly raise and lower
implement carefully to ensure that the drawbar, tires,
and other equipment on the tractor do not contact
cutter frame. Move or remove drawbar if it interferes
with the cutter.
8. Manually adjust one of the two lower lift arms up or
down to level the Rotary Cutter from left to right.
9. Manually adjust the length of the top-link to level the
Rotary Cutter from front to rear. Final deck leveling
adjustments will be made later.
10. The arm lift rods on your tractor’s 3- point hitch
should be adjusted to allow for lateral float. Please
consult you tractor’s manual for adjusting
instructions.
Tractor Hook-Up
Figure 1-3
21422
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Comments to this Manuals

No comments