Land Pride PR2596 User Manual download pdf (Page 20)

Section 5: Maintenance & Lubrication

PR2572 & PR2596 Powered Rakes 314-132M

6/06/06

Land Pride

Table of Contents

Bottom and Top Seal Installation

If the bottom and top seals (#7) Figure 5-1 on page 17

need replacing refer to Figure 5-2 and Figure 5-3.

Top Bearing Seal Location

Figure 5-2

Bottom Bearing Seal Location

Figure 5-3

15833

15836

Friction Clutch PTO

Refer to Figure 5-4:

Powered Rake drive components are protected from

shock loads by a two plate friction clutch located

between the gearbox and the drive shaft.

The clutch should slip during operation to protect the

powered rake from excessive loads.

Prior to initial operation and after long periods of

inactivity, the Friction Clutch should be “run-in”.

1. Tighten all 4 nuts uniformly until the spring load is low

enough that the clutch slips freely with the PTO

engaged.

2. Engage the PTO until the clutch rotates one

revolution.

3. Turn nuts fully back. Clutch is ready for use.

Friction Clutch “Run In”

Figure 5-4

10103

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

No comments

Land Pride PR2596 User Manual Page 20