Land Pride Accuz Z52 User Manual download pdf (Page 22)

Section 3 Adjustments

Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M 03/11/03

Land Pride

Section 3

Adjustments

WARNING!

Unless speciﬁcally required, DO NOT have engine running

when servicing or making adjustments to the mower. Place

control levers in the park brake position and remove ignition

switch key. Repairs or maintenance requiring engine power

should be performed by trained personnel only. To prevent

carbon monoxide poisoning, be sure proper ventilation is

available when engine must be operated in an enclosed area.

Read and observe safety warnings in front of manual.

Your Accu Z was adjusted before it left the factory and was

checked during pre-delivery setup. However, after start-

up and continued use, a certain amount of break-in wear

will cause some adjustments to change.

Remain alert for unusual noises, they could be signaling a

problem. Visually inspect the machine for any abnormal

wear or damage. A good time to detect potential problems

is while performing scheduled maintenance service.

Correcting the problem as quickly as possible is the best

insurance.

WARNING!

Keep your machine clean and remove heavy deposits of trash

and clippings, they can cause engine ﬁres and hydraulic

overheating as well as excessive belt wear.

Clear away heavy build-up of grease, oil and dirt,

especially in the area of reservoir and oil and engine

combustion air; minute dust particles are abrasive to

close-tolerance engine and hydraulic assemblies.

Some repairs require the assistance of a trained service

mechanic and should not be attempted by unskilled

personnel. Consult your Land Pride service center when

assistance is needed.

Torque Values

WARNING!

Particular attention must be given to tightening the drive wheel

lug nuts and wheel motor nuts. Failure to correctly torque these

items may result in the loss of a wheel, which can cause serious

damage or personal injury.

Refer to “Torque Values” on page 32.

It is recommended that the following be checked after the

first 2 hours of initial operation, initially and every 50 hours

following removal for repair or replacement.

Wheel lug nuts

Wheel motor nut

Blade spindle bolts (top and bottom)

For engine torque values, see engine owner’s manual.

Steering Linkage

The neutral adjustment for the control levers in the neutral

position is discussed in this section.

The steering has been factory adjusted to eliminate

creeping when the control levers are in the neutral position

(Refer to Figure 3-1).

However, should the mower begin to creep, adjustments

can be made as outlined on the following page.

Control Lever In Neutral Position

Figure 3-1

19078

Control

Lever

Park Brake

Slot

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

Comments to this Manuals

No comments

Land Pride Accuz Z52 User Manual Page 22

Comments to this Manuals

Related products and manuals for Lawnmowers Land Pride Accuz Z52