Land Pride RCP3060 User Manual download pdf (Page 44)

Section 6: Maintenance & Lubrication

RCP2660, RCPM2660, RCP3060 and RCPM3060 Parallel Arm Rotary Cutter 316-111M

12/16/08

Land Pride

Table of Contents

Motor Spindle Hub

Refer to Figure 6-5:

The motor spindle hub (#1), has two cavity plugs (#2)

located on one side of the housing.

1. Disengage PTO driveline.

2. Position cutter deck in transport position and secure

with deck safety chain.

3. Set tractor park brake, shut engine off and remove

switch key before continuing.

4. Remove one of the cavity plugs (#2) to check fluid

level. Fluid level should be within 1/2" from top of port

opening.

5. Add 80-90 weight gearlube as required. Full capacity

of motor housing is approximately 1/3 pint.

6. Install cavity plug and tighten.

Hydraulic Reservoir

Refer to Figure 6-6:

The hydraulic reservoir has an effective capacity of 35

gallons. A dipstick located on the filler cap indicates

correct reservoir fluid level. Disengage PTO driveline

and shut tractor engine off before checking fluid level.

Add hydraulic fluid as needed to fill to full mark on

dipstick.

A filter mounted on the hydraulic reservoir is used to

clean the return hydraulic fluid to the reservoir tank.

Replace filter element ever 2 years with a conventional

10 micron filter.

Speed Increaser

Refer to Figure 6-7:

The speed increaser is mounted between the PTO

driveline and hydraulic pump. It is used to increases PTO

speed from 540 rpm or 1000 rpm to approximately 2000

rpm at the pump.

Check oil level by removing level plug located on the

gearbox side.Oil level should be level with bottom of plug

hole. Add oil if low through the breather/fill cap opening.

Change oil after the first 100 working hours. Make

successive changes every 1500 hours thereafter or ever

year, whichever comes first. Drain old oil out through the

drain plug hole located at the bottom. Be sure to reinstall

drain plug and tighten before filling gearbox. Fill gearbox

with 80-90W EP gearlube. Reinstall level plug and

tighten. Replace breather/fill cap.

Motor/Spindle Hub

Figure 6-5

Filter Removal

Figure 6-6

Speed Increaser

Figure 6-7

13994

12469

Fill Cap &

Dipstick

10 Micron

Filter Element

12270

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Comments to this Manuals

No comments

Land Pride RCP3060 User Manual Page 44

Comments to this Manuals

Related products and manuals for Tractor Land Pride RCP3060