Land-pride AT2572 User Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
13
Section 2: Operating Instructions
8/08/12
FD2560, FD2572, AT2560 & AT2572 Grooming Mower, 3-spindle 310-148M
Land Pride
Table of Contents
Operating Instructions
1. Clear the area to be mowed of objects and debris
that might be picked up and thrown by the mower
blades.
2. Grass is best cut when it is dry. Mowing wet grass
can cause plugging resulting in grassclumps behind
the mower.
3. Grass should be mowed frequently as shorter
clippings deteriorate faster.
4. If mowing extremely tall grass, it is best to raise
cutting height and mow the area, then lower cutting
height and mow a second time at the desired height.
5. Lower mower to ground. Set tractor throttle at
approximately1/4open. Engage PTOtostartblades
rotating.
6. Operate only with 540rpm PTO tractor.
7. At first, begin mowing at a slow forward speed and
shift up until the desired speed is achieved -
maintaining 540 PTO rpm.
8. Mower blades will cut better at a faster rotor speed
than at reduced throttle.
9. After mowing the first 50 feet, stop and check to see
that the mower is adjusted properly.
10. Do not make sharp turns or attempt to back up while
mower is on the ground.
11. Do not engage PTO with mower in the fully raised
position. Do not engage PTO at full throttle.
12. After mowing disconnect tractor PTO and follow
transporting procedures.
!
CAUTION
When mowing in sandy soil areas, wear may occur to your
mower blades caused from sand erosion. Frequent inspection
should be made and blades replaced if damaged
Pre-Start-up Checklist
Read and follow the “Safety Rules” carefully.
Oil Level in gearbox
All plugs and caps in gearbox have been replaced and tight-
ened properly.
All mower blades, bolts & nuts are tight
Inspect the blades. Make note of the wear to the blades and
the sharpness of the blades.
All guards and shields are in place and secure.
Grease PTO shaft and all other grease fittings.
Make a thorough examination of the PTO shafts. Also check
the connection to the gearbox and tractor PTO.
Clear the area to be mowed of rocks, branches and other for-
eign objects.
Transporting
!
CAUTION
Always disengage tractor PTO before transporting mower to
avoid injury from thrown objects or blade contact.
!
CAUTION
When traveling on public roads whether at night or during the
day, use accessory lights and devices for adequate warning to
operator’s of other vehicles. Comply with all federal, state and
local laws.
!
CAUTION
The mower is wider than your tractor so care should be taken
when encountering oncoming traffic and roadside obstructions.
1. When raising the mower to the transport position, be
sure that drivelinedoes not contact tractor or mower.
Adjust the tractor’s 3-point hitch lift height so that the
PTO shaft does not contact the mower deck. Mower
should not be transported without tractor’s upper 3-
Point link attached.
2. Be sure to reduce tractor ground speed when
turning; and, leave enough clearance so the mower
does not contact obstacles such as buildings, trees
or fences.
3. Select a safeground travel speed when transporting
from one area to another. When traveling on
roadways, transport in such a way that faster moving
vehicles may pass you safely.
4. Whentravelingoverrough orhillyterrain,shift tractor
to a lower gear.
IMPORTANT: Always disengagePTO before raising
the mower to transport position.
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Comments to this Manuals

No comments