Land Pride RCR1884 User Manual download pdf (Page 13)

Section 1: Assembly and Set-Up

9/24/08

RCR1884 Series Rotary Cutters 312-880M

Land Pride

Table of Contents

Single Tailwheel Assembly

Refer to Figure 1-4:

1. Slide adjustment plate (#1) onto tailwheel arm (#2).

2. Attach front end of tailwheel arm (#2) to tailwheel

mounting bracket with 5/8”-11 x 3 1/4” GR5 hex head

bolt (#6), 5/8” ﬂat washer (#9) and 5/8” locknut (#7).

NOTE: Do not tighten hardware until assembly

is complete. See “Torque Values Chart” on page

33 for correct torques.

IMPORTANT: If chain guards are not used, install

tailwheel arm (#2) in front hole of tailwheel mounting

bracket as shown. If chain guards are used, install in

rear hole.

3. Assemble tailwheel adjusting brackets (#3 & #4) to

deck rear with four 1/2”-13 x 1 1/2” GR5 carriage

bolts (#5) and 1/2” flange locknuts (#8).

4. Install shim washer (#10) onto yoke spindle (#12)

and insert spindle into tailwheel arm (#2). Install 2nd

shim washer (#10) onto yoke spindle and secure with

roll pin (#11).

5. Assemble tailwheel adjusting plate (#1) to adjusting

brackets (#3 & #4) with two 1/2” -13 x 1 1/2” GR5 hex

head bolts (#5) and 1/2” flange locknuts (#8).

6. Refer to “Single Tail Wheel Height Adjustment”

on page 19 for adjusting instructions.

7. Tighten all locknuts to correct torque.

Single Tailwheel Assembly

Figure 1-4

24655

Tailwheel

Mounting Bracket

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

No comments

Land Pride RCR1884 User Manual Page 13