Land Pride RCR1884 User Manual download pdf (Page 21)

Section 2: Adjustments

9/24/08

RCR1884 Series Rotary Cutters 312-880M

Land Pride

Table of Contents

Single Tail Wheel Height Adjustment

Refer to Figure 2-3:

The single tailwheel must be adjusted if cutting height is

too high or too low.

1. Use tractor’s 3-point hydraulic control to lift the

tailwheel off the ground.

2. Remove 1/2” -13 x 1 1/2" GR5 carriage head bolt (#5)

and 1/2” hex flange locknut (#6).

3. Adjust tailwheel (#2) up or down to desired cutting

height by repositioning adjusting plate (#1) and

replace attaching hardware.

Dual Tail Wheel Height Adjustment

Refer to Figure 2-3:

The dual tailwheels must be adjusted if cutting height is

too high or too low.

1. Use tractor’s 3-point hydraulic control to lift the

tailwheels off the ground.

2. Remove 1/2” -13 x 3 1/2" GR5 bolts (#2).

3. Adjust tailwheel (#1) up or down to desired cutting

height and reinsert 1/2” -13 x 3 1/2" GR5 bolts (#2).

4. Secure 1/2” bolts with 1/2” flange lock nuts (#3).

Tighten lock nuts to correct torque.

Nominal Cutting Height

Figure 2-5

24661

For best cutting efﬁciency, adjust the

lower 3-point arm height such that the

front cutter blade is approximately 1"

lower than the rear cutter blade.

Single Tailwheel Height Adjustment

Figure 2-3

Dual Tailwheel Height Adjustment

Figure 2-4

24662

24689

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 37 38

No comments

Land Pride RCR1884 User Manual Page 21