Land Pride RCR1884 User Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 38
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
15
Section 1: Assembly and Set-Up
9/24/08
RCR1884 Series Rotary Cutters 312-880M
Land Pride
Table of Contents
3-Point Tractor Hook-Up
Refer to Figure 1-10:
!
DANGER
Tractor hook-up to equipment is dangerous and can result in
serious injury or death. Do not allow anyone to stand between
the cutter and tractor during hook-up operations. Do not
operate the hydraulic 3-point lift controls while someone is
directly behind the tractor or near the cutter.
You will need to purchase two adapter bushings if
attaching this cutter to a 3-Point Category I hitch. See
“Category l Adapter Bushings” on page 9 for additional
information and bushing part number.
The tractor’s lower 3-Point arms must be stabilized to
prevent side-to-side movement. Most tractors have sway
blocks or adjustable chains for this purpose.
1. Locate on a flat and level concrete surface.
2. Slowly back tractor up to the Rotary Cutter while using
the tractor’s 3-point hydraulic control to position the
tractor’s lower hitch link holes (#1) in the clevis and
aligned with the hitch pins (#2).
3. Engage tractor park brake, shut tractor engine off
and remove key before dismounting from tractor.
4. Attach lower hitch link holes (#1) to the clevises with
hitch pins (#2). Secure with linch pins (#3).
5. Connect top center link (#4) to the upper hitch (#5)
with customer supplied clevis pin and linch pin. If
required, start tractor and slowly raise 3-point hitch
to align center link with hitch pin hole.
6. Ensure that lower hitch arms are blocked to prevent
excessive side movement.
7. Return to tractor and slowly operate controls up and
down to check for clearance between cutter deck and
tractor tires and drawbar. Move or remove drawbar if
it interferes.
8. Manually adjust a lower lift arm (#1) up or down to
level the Rotary Cutter from left to right.
9. Manually adjust the center link (#4) length to level
cutter from front to rear.
10. Final deck leveling adjustments will be made later.
11. The lift link rods on your tractor’s 3- point hitch should
be adjusted to allow for lateral float. Please consult
you tractor’s manual for adjusting instructions.
3-Point Tractor Hook-Up
Figure 1-10
24660
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Comments to this Manuals

No comments