Land Pride RCR1884 User Manual download pdf (Page 14)

Section 1: Assembly and Set-Up

RCR1884 Series Rotary Cutters 312-880M

9/24/08

Land Pride

Table of Contents

Dual Tailwheel Assembly

Refer to Figure 1-5:

1. Attach tailwheel bracket (#2) to left side of cutter

deck with four 1/2” -13 x 1 1/2” GR5 hex head

bolts (#6), 1/2” flat washers (#11) and 1/2” flange

lock nuts (#9).

2. Attach tailwheel arm (#1) to tailwheel bracket (#2)

with 5/8”-11 x 3 1/4” GR5 hex head bolt (#8), 5/8” flat

washer (#12) and 5/8” lock nut (#9).

NOTE: Do not tighten hardware until assembly

is complete. See “Torque Values Chart” on page

33 for correct torques.

IMPORTANT: If rear chain guard is used, install

tailwheel arm (#1) in rear hole of bracket (#2) as

shown. If rear metal deflector is used, install

tailwheel arm (#1) in front hole of bracket (#2).

Dual Tailwheel Assembly

Figure 1-5

24665

3. Assemble tailwheel adjusting brackets (#3 & #4) to

left side of deck using four 1/2”-13 x 1 1/2” GR5

carriage bolts (#7) and 1/2” flange lock nuts (#10).

4. Install shim washer (#13) onto yoke spindle (#15)

and insert spindle into tailwheel arm (#1). Slide 2nd

shim washer (#13) onto yoke spindle and secure with

roll pin (#14).

5. Install two 1/2” -13 x 3 1/2” GR5 hex head bolts (#5)

and hex flange lock nuts (#10) in adjusting brackets

(#3 & #4) as shown.

6. Tighten all nuts to correct torque.

7. Repeat steps 1 through 6 for right side of cutter.

8. Refer to “Dual Tail Wheel Height Adjustment” on

page 19 for adjusting instructions.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

No comments

Land Pride RCR1884 User Manual Page 14